Process a measurement inspection instruction

When processing a measurement inspection instruction, you are asked to perform a measurement.
  1. Choose Inspection Management > Inspections in the Navigation Pane.
  2. Find and select the inspection.
  3. Select the vertical tab Instructions, and choose the sub tab Inspection Instructions.
  4. Select the measurement inspection instruction.
  5. In the Ref ID window in the toolbar of the inspection instruction, enter the required Ref ID and click Enter.
    The entered Ref ID will be included in every inspection instruction that is processed.
  6. Click Process Inspection Instruction .
  7. In the Ref ID window, enter any required Ref ID.
    If a Ref ID was entered in step 5, this field is prefilled.
  8. Select the needed number of samples and click Next, if the inspection must be processed on samples.
  9. In option group Measurements in the field Input enter the value of the measurement and press ENTER.
    If the average value of the entered measurements does not meet the control and/or specification limits or the maximum allowed difference between the highest and the lowest measurement value, this value will be colored red in the option group Settings.
    If a measurement value is colored red or orange in the table Measurements, further information will be shown under the table when selecting the value.
  10. Repeat the previous step to enter another measurement.
  11. Where applicable, add additional information in the text box Comment.
  12. Click Finish.